SEP 12 network threat protection not showing in GUI
After installing full package of SEP 12 you may not see Network Threat protection in SEP GUI.
This can be solved by following below steps.
1. Open cmd using run as administrator option,
2. Change to directory containing smc.exe and smcgui.exe (usually the bin directory inside installed directory, in my case C:\Program Files\Symantec\Symantec Endpoint Protection\12.1.671.4971.105\Bin)
3. run command " smc -stop", wait till symantec management console stops.
4. run command " smcgui.exe /UNREGSERVER"
This can be solved by following below steps.
1. Open cmd using run as administrator option,
2. Change to directory containing smc.exe and smcgui.exe (usually the bin directory inside installed directory, in my case C:\Program Files\Symantec\Symantec Endpoint Protection\12.1.671.4971.105\Bin)
3. run command " smc -stop", wait till symantec management console stops.
4. run command " smcgui.exe /UNREGSERVER"
5. run command "smcgui.exe /REGSERVER"
6. run command "smc -start", Check by opening SEP GUI, Network Threat protection will be available now.
that should do the trick!!!
No comments:
Post a Comment